Systems Specifications Metal Storage tanks

Surface Preparation: Ensure surfaces are degreased and free of contamination using Protective Paints A925 - Metal degreaser

(follow instructions as per data sheet). Ensure all Corroless data sheet are strictly followed. Ensure surfaces are free from

preparation debris and are clean and dry. Apply 1^st coat within 4 hours of abrasive blasting. Practical coverage is project dependent.

Click on links to obtain data sheets

DFT = Dry Film Thickness WFT = Wet Film thickness TDF = Total Dry Film thickness

Spec 010

Exterior Moderate exposure	Abrasive Blasting Sa 3 of AS 1627.9 (Two pack system)
1st Coat	Apply Corroless E at 80 µ WFT (50 µ DFT)
2^nd and 3^rd coat	Apply Corroless RF 60 at 50 µ WFT (30µ DFT ) tinted to approved colour

TDF = 110 microns minimum

Spec 011

External Exposure and chemicals	Less Than 10 km from coastal areas of industrial activity Abrasive Blasting Sa 3 of AS 1627.9 (Two pack system)
1^st coat:	Apply Corroless EP at 210 µ WFT( 200 µ DFT)
2^nd and 3^rd	Apply Corroless RF 60 at 50 µ WFT ( 30 DFT) tinted to approved colour

TDF = 260 microns minimum

Spec 012

Internal Metal Tanks Heavy Duty	Tank Lining, fuel tanks and bulk storage tanks. Abrasive Blasting Sa 3 of AS 1627.9 (Two pack system)
1^st coat:	Apply Corroless EP at 210 µ WFT( 200 µ DFT)
2^nd and 3^rd	Apply Corroless RF 35 at 210 µ WFT ( 200 DFT)

TDF = 600 microns minimum

Specification subject to NZS/AS 1627; Preparation of surfaces NZS/AS 2312 Protection of mild steel; AS 3894 Determination of Dry Film thickness