Systems Specifications Specific Conditions

Surface Preparation: Ensure surfaces are degreased and free of contamination using Protective Paints A925 - Metal degreaser (follow instructions as per data sheet). Ensure all Corroless data sheet preparation procedures are strictly followed. Ensure surfaces are free from preparation debris and are clean and dry.Apply 1^st coat within 4 hours of abrasive blasting. Practical coverage is project dependent.

Click onto links to obtain Corroless data sheets.

DFT = Dry Film Thickness WFT = Wet Film thickness TDF = Total Dry Film thickness

Spec 016

High Temperatures up to 200°C	Geothermal Hydrothermal steam pipes and bores Abrasive Blasting Sa 3 of AS 1627.9 (Two pack system)
1st Coat	Apply Corroless E at 80 µ WFT (50 µ DFT)
2^nd and 3^rd coat	Apply Corroless RF 60 at 50 µ WFT ( 30 DFT) tinted to approved colour

TDF = 110 microns minimum

Spec 017

Non-Skid Surfaces	Abrasive Blasting Sa 3 of AS 1627.9 (Two pack system)
1^st coat:	Apply Corroless EP at 210 µ WFT( 200 µ DFT).Spread 100g/m2 of aluminium oxide into wet coating
2^nd and 3^rd	Apply Corroless RF 60 at 50 µ WFT ( 30 DFT) tinted to approved colour

The RF 60 will encapsulate the grit leaving a suitable non-skid profile.

TDF = 260 microns minimum

Spec 018

Int/Immersion subject to abrasion	Abrasive Blasting Sa 3 of AS 1627.9 (Two pack system)
1^st coat:	Apply Corroless EP at 210 µ WFT( 200 µ DFT)
2^nd and 3^rd	Apply Corroless EP at 210 µ WFT( 200 µ DFT)

TDF = 600 microns minimum

Specification subject to NZS/AS 1627; Preparation of surfaces NZS/AS 2312 Protection of mild steel; AS 3894 Determination of Dry Film thickness